alternative exposure, in sec: 2 Gain: 3 ADC rate: 6 date[DATEMAX]: 20Nov2009 Experiment Local Timing: 193202 (hhmmss or 0) Experiment UTC Timing: 193202 (hhmmss or 0) Shutter Control: 3 (Normal, Disabled Open, Disabled Close) experiment datatype: 1 (long) Number of Frames in File: 1 Number of Accumulations: 1 Experiment readout time: 9678.37 BackGround Applied: 1 (1 if background subraction done ) Auto Clean Active T/F: 0 flat Field Applied: 0 (1 if flat field was applied) Set to 1 if blemish removal applied: 0 Set to 1 if comsic raw removal applied: 0
Hardware Version: 0 Definition of OutPut BNC: 1 Amp Switching Mode: 0 Detector x dimension chip: 1024 timing mode: 1 alternative exposure, in sec: 2 Virtual Chip X dim: 0 Virtual Chip Y dim: 0 y dim of CCD or detector: 1024 date[DATEMAX]: 20Nov2009 Virtual Chip Flag On/Off: 0 Old numer of scans: -1 (should always be -1) Used with Asiny Mode: 0 Shutter Control: 3 (Normal, Disabled Open, Disabled Close) Absorb Live (On/Off): 0 Reference Strip or File: 0 Able to do Virtual Chip: 0 Threshold Min Live: 0 (On/Off) Threshold Minimun Value: 0 Threshold Max Live: 0 (On/Off) Threshold Maximum Value: 0 T/F Spectrograph Used: 0 Center Wavelength (nm): 0 T/F file is Glued: 0 Starting Wavelength (nm): 0 Ending Wavelength (nm): 0 Minimum Overlap (nm): 0 Final Resolution (nm): 0 Pulser Type: 0 (0 = None, PG200 = 1, PTG=2, DG535=3) T/F Custom Chip Used: 0 Pre Pixel in X direction: 0 Post Pixels in X direction: 8 Pre Pixel in Y direction: 24 Post Pixels in Y direction: 24 asynchron enable flag: 0 (0=off) experiment datatype: 1 (long) Repetitive/Sequential: 0 Num PTG On-Chip Accums: 0 Num Exp Repeats: 0 (Pulser SW Accum) Width Value for Rep. Pulse: 0 (usec) Delay? for Rep. Pulse: 0 (usec) Start Width for Seq. pulse: 0 (usec) End Width for Seq. pulse: 0 (usec) Start Delay for Seq. pulse: 0 (usec) End Delay for Seq. pulse: 0 (usec) Increments: 0 (1 = fixed, 2 = Exponential) PI-Max type controller flag: 0 PI-max mode: 0 PI-max gain: 0 BackGround Applied: 1 (1 if background subraction done ) T/F PI-max 2ns Board Used: 0 min # of strips per skips: 4 # of min-blocks before geo skps: 250 Spectro Mirror Location: 0 0 (0 = Not Present) Spectro Slit Location: 0 0 0 0 (0 = Not Present) T/F Custom Timing Used: 0 Experiment Local Timing: 193202 (hhmmss or 0) Experiment UTC Timing: 193202 (hhmmss or 0) User Units for Exposure: 3 ADC offset: 1878 ADC rate: 6 ADC type: 9 ADC resolution: 4 ADC bit adjust: 0 Gain: 3 File comments 1: File comments 2: File comments 3: File comments 4: File comments 5: geometric ops: 0 (rotate 0x01, reverse 0x02, flip 0x04) intensity display string: Pixel cleans: 1 number of skips per clean: 1024 Spectrograph Mirror Positions: 0 0 Spectrograph Slit Positions: 0 0 0 0 Auto Clean Active T/F: 0 UseContCleanActive T/F: 0 Absorb Strip Number: 0 Spectrograph Slit Pos. Units: 0 Spectrograph Grating Grooves: 0 # of source comp. diodes: 0 y dimension of raw data: 1024 0 = scrambled, 1 = unscramble: 1 T/F Continuous Cleans Timing Option: 0 T/F External Trigger Timing Option: 0 Number of scans (Early WinX): -1 Number of Accumulations: 1 Experiment readout time: 9678.37 T/F Triggered Timing Option: 0 Spare 2: Version of SW creating this file: 2.5.25 Mar2009 Type: 22 (This type does not exist) flat Field Applied: 0 (1 if flat field was applied) Spare_3: Kinetics Trigger Mode: 1 Data Label: Intensity Spare_4: Name of Pulser File: (with Pulse Widths/Delays (for Z-Slice)) Name of Absorbtance File: (if FIle Mode) Number of time experiment repeated: 0 Number of time experiment accumulated: 0 Set to 1 if this file contains YT data: 0 Vert Clock Speed in micro_sec: 0 Set to 1 if accum done by Hardware: 0 Set to 1 if store sync used: 1 Set to 1 if blemish removal applied: 0 Set to 1 if comsic raw removal applied: 0 if cosmic ray applied, this is type: 0 Threshold of cosmiv ray removal: 50 Number of Frames in File: 1 max intensity data (future): 0 min intensity data (future): 0 y axis label: Strip shutter type: 6 shutter compensation time: 0 readout mode: 1 (full, kinetic, etc) window size for knietics only: 0 clock speed for kinetics and frame transfer: 0 computer interface : 22 (isa-taxi,pci, eisa, etc.) Num of ROI: May be more than the 10 allowed in this header (if 0 assume 1) Num ROIs In Experiment: 1 (May be more than the 10 allowed in this header (if 0 assume 1)) Spare_5: Controller Num: 1 (if multiple controllers system will have controller number data came from. This is a future item) Which software package created this file: 1 number of ROIs used: 1 (if 0, assume 1) left x start value: 1 0 0 0 0 0 0 0 0 0 right x start value: 1024 0 0 0 0 0 0 0 0 0 amount x is binned in hw: 1 0 0 0 0 0 0 0 0 0 top y start value: 1 0 0 0 0 0 0 0 0 0 bottom y start value: 1024 0 0 0 0 0 0 0 0 0 amount y is binned/grouped in hw: 1 0 0 0 0 0 0 0 0 0 Flat field file name: background sub. file name: Back.SPE blemish file name: version of this file header: 2.2 Reserved for YT information: 0x01234567L if file created by WinX: 1.90887e+007 ======================================================= X Calibration data offset for absolute scaling: 0 factor for absolute scaling: 0 select scaling unit: 1 reserved: NOT SHOWN special string for scaling: NOT SHOWN reserved: NOT SHOW flag if calibration if valid: 1 current input values for "calib_value": 0 linear UNIT and used in the "poly_coeff": 1 ORDER of calibration POLYNOM: 1 valid calibration data pairs: 0 pixelpos. of calibration data: 0 0 0 0 0 0 0 0 0 0 calibration VALUE as above pos: 0 0 0 0 0 0 0 0 0 0 polynom COEFFICIENTS: 1 1 0 0 0 0 laser wavenumber for reative WN: 0 reserved: 0 If set to 200, valid label below: 0 Caliobration label (NULL term'd): NOT SHOWN Calibration Expansion area: NOT SHOWN ======================================================= Y Calibration data offset for absolute scaling: 0 factor for absolute scaling: 0 select scaling unit: 0 reserved: NOT SHOWN special string for scaling: NOT SHOWN reserved: NOT SHOW flag if calibration if valid: 0 current input values for "calib_value": 0 linear UNIT and used in the "poly_coeff": 0 ORDER of calibration POLYNOM: 0 valid calibration data pairs: 0 pixelpos. of calibration data: 0 0 0 0 0 0 0 0 0 0 calibration VALUE as above pos: 0 0 0 0 0 0 0 0 0 0 polynom COEFFICIENTS: 0 0 0 0 0 0 laser wavenumber for reative WN: 0 reserved: 0 If set to 200, valid label below: 0 Caliobration label (NULL term'd): NOT SHOWN Calibration Expansion area: NOT SHOWN End cal info======================================================= If set to 200, valid label below: 0 special intensity scaling string: NOT SHOWN Spare: NOT SHOWN spectrometer type: 0 (acton, spex, etc) spectrograph model: 0 (type dependent) pulser burst mode: 0 (on/off) pulser triggers per burst: 0 pulser burst period: 0 (usec) pulser bracket pulsing: 0 (on/off) pulser bracket pulsing type: 0 pulser fast exponential time constant: 0 (usec) pulser fast exponential amplitude constant: 0 (usec) pulser slow exponential time constant: 0 (usec) pulser slow exponential amplitude constant: 0 (usec) analog gain was used: 0 avalanche gain was used: 0 avalanche gain value: 0 Always the LAST value in the header: 21845 End HEADER======================================================= 1048576 Data values Read in as int32 Data reshaped to 1024 by 1024 by 1 and converted to double Some Data ---------------------------------------------------------------- Row Column 1 101 201 301 401 501 601 701 801 901 1001 0001 -1 10 -9 -8 14 0 -4 -14 1 -5 -2 0051 0 10 1 6 -7 3 -7 6 16 16 5 0101 6 -2 5 -1 -3 -9 3 -2 -2 3 -7 0151 6 8 -6 -1 7 -2 -3 -5 4 6 -3 0201 12 -4 0 3 2 -1 -9 0 16 0 11 0251 2 -12 16 -1 -2 1 15 -2 -5 5 11 0301 3 12 -4 14 -8 -15 -9 -1 3 -8 5 0351 4 2 -3 9 -20 8 12 -8 -3 4 4 0401 2 1 -13 -5 -3 4 -2 7 3 6 11 0451 11 0 6 -4 2 1 1 -6 -11 16 7 0501 -2 -12 7 7 3 15 -5 6 -8 -3 -13 0551 9 5 13 -2 -2 -11 -1 7 3 0 -1 0601 18 -1 -3 -4 7 16 1 12 7 -2 14 0651 -3 -9 5 8 6 -6 0 7 1 17 -8 0701 10 8 4 4 1 2 -17 -11 -8 -8 -1 0751 2 -2 -12 -4 8 6 15 4 1 1 9 0801 -1 5 12 -8 11 -9 2 -5 3 -4 -22 0851 12 15 -10 8 4 15 4 -5 0 -2 4 0901 -2 6 2 -2 8 8 2 12 -6 -11 3 0951 15 -12 5 -2 -2 6 -1 8 24 -16 -1 1001 11 -15 -10 -1 -11 2 7 -3 -5 3 7