alternative exposure, in sec: 0.1 Gain: 3 ADC rate: 6 date[DATEMAX]: 24Nov2009 Experiment Local Timing: 222018 (hhmmss or 0) Experiment UTC Timing: 222018 (hhmmss or 0) Shutter Control: 2 (Normal, Disabled Open, Disabled Close) experiment datatype: 3 (ushort) Number of Frames in File: 1 Number of Accumulations: 1 Experiment readout time: 9678.37 BackGround Applied: 0 (1 if background subraction done ) Auto Clean Active T/F: 0 flat Field Applied: 0 (1 if flat field was applied) Set to 1 if blemish removal applied: 0 Set to 1 if comsic raw removal applied: 0
Hardware Version: 0 Definition of OutPut BNC: 1 Amp Switching Mode: 0 Detector x dimension chip: 1024 timing mode: 1 alternative exposure, in sec: 0.1 Virtual Chip X dim: 0 Virtual Chip Y dim: 0 y dim of CCD or detector: 1024 date[DATEMAX]: 24Nov2009 Virtual Chip Flag On/Off: 0 Old numer of scans: -1 (should always be -1) Used with Asiny Mode: 0 Shutter Control: 2 (Normal, Disabled Open, Disabled Close) Absorb Live (On/Off): 0 Reference Strip or File: 0 Able to do Virtual Chip: 0 Threshold Min Live: 0 (On/Off) Threshold Minimun Value: 0 Threshold Max Live: 0 (On/Off) Threshold Maximum Value: 0 T/F Spectrograph Used: 0 Center Wavelength (nm): 0 T/F file is Glued: 0 Starting Wavelength (nm): 0 Ending Wavelength (nm): 0 Minimum Overlap (nm): 0 Final Resolution (nm): 0 Pulser Type: 0 (0 = None, PG200 = 1, PTG=2, DG535=3) T/F Custom Chip Used: 0 Pre Pixel in X direction: 0 Post Pixels in X direction: 8 Pre Pixel in Y direction: 24 Post Pixels in Y direction: 24 asynchron enable flag: 0 (0=off) experiment datatype: 3 (ushort) Repetitive/Sequential: 0 Num PTG On-Chip Accums: 0 Num Exp Repeats: 0 (Pulser SW Accum) Width Value for Rep. Pulse: 0 (usec) Delay? for Rep. Pulse: 0 (usec) Start Width for Seq. pulse: 0 (usec) End Width for Seq. pulse: 0 (usec) Start Delay for Seq. pulse: 0 (usec) End Delay for Seq. pulse: 0 (usec) Increments: 0 (1 = fixed, 2 = Exponential) PI-Max type controller flag: 0 PI-max mode: 0 PI-max gain: 0 BackGround Applied: 0 (1 if background subraction done ) T/F PI-max 2ns Board Used: 0 min # of strips per skips: 4 # of min-blocks before geo skps: 250 Spectro Mirror Location: 0 0 (0 = Not Present) Spectro Slit Location: 0 0 0 0 (0 = Not Present) T/F Custom Timing Used: 0 Experiment Local Timing: 222018 (hhmmss or 0) Experiment UTC Timing: 222018 (hhmmss or 0) User Units for Exposure: 3 ADC offset: 1878 ADC rate: 6 ADC type: 9 ADC resolution: 4 ADC bit adjust: 0 Gain: 3 File comments 1: File comments 2: File comments 3: File comments 4: File comments 5: geometric ops: 0 (rotate 0x01, reverse 0x02, flip 0x04) intensity display string: Pixel cleans: 1 number of skips per clean: 1024 Spectrograph Mirror Positions: 0 0 Spectrograph Slit Positions: 0 0 0 0 Auto Clean Active T/F: 0 UseContCleanActive T/F: 0 Absorb Strip Number: 0 Spectrograph Slit Pos. Units: 0 Spectrograph Grating Grooves: 0 # of source comp. diodes: 0 y dimension of raw data: 1024 0 = scrambled, 1 = unscramble: 1 T/F Continuous Cleans Timing Option: 0 T/F External Trigger Timing Option: 0 Number of scans (Early WinX): -1 Number of Accumulations: 1 Experiment readout time: 9678.37 T/F Triggered Timing Option: 0 Spare 2: Version of SW creating this file: 2.5.25 Mar2009 Type: 22 (This type does not exist) flat Field Applied: 0 (1 if flat field was applied) Spare_3: Kinetics Trigger Mode: 1 Data Label: Intensity Spare_4: Name of Pulser File: (with Pulse Widths/Delays (for Z-Slice)) Name of Absorbtance File: (if FIle Mode) Number of time experiment repeated: 0 Number of time experiment accumulated: 0 Set to 1 if this file contains YT data: 0 Vert Clock Speed in micro_sec: 0 Set to 1 if accum done by Hardware: 0 Set to 1 if store sync used: 1 Set to 1 if blemish removal applied: 0 Set to 1 if comsic raw removal applied: 0 if cosmic ray applied, this is type: 0 Threshold of cosmiv ray removal: 50 Number of Frames in File: 1 max intensity data (future): 0 min intensity data (future): 0 y axis label: Strip shutter type: 6 shutter compensation time: 0 readout mode: 1 (full, kinetic, etc) window size for knietics only: 0 clock speed for kinetics and frame transfer: 0 computer interface : 22 (isa-taxi,pci, eisa, etc.) Num of ROI: May be more than the 10 allowed in this header (if 0 assume 1) Num ROIs In Experiment: 1 (May be more than the 10 allowed in this header (if 0 assume 1)) Spare_5: Controller Num: 1 (if multiple controllers system will have controller number data came from. This is a future item) Which software package created this file: 1 number of ROIs used: 1 (if 0, assume 1) left x start value: 1 0 0 0 0 0 0 0 0 0 right x start value: 1024 0 0 0 0 0 0 0 0 0 amount x is binned in hw: 1 0 0 0 0 0 0 0 0 0 top y start value: 1 0 0 0 0 0 0 0 0 0 bottom y start value: 1024 0 0 0 0 0 0 0 0 0 amount y is binned/grouped in hw: 1 0 0 0 0 0 0 0 0 0 Flat field file name: background sub. file name: C:\BlueInLine_Dec2009\20Nov2009\Back.SPE blemish file name: version of this file header: 2.2 Reserved for YT information: 0x01234567L if file created by WinX: 1.90887e+007 ======================================================= X Calibration data offset for absolute scaling: 0 factor for absolute scaling: 0 select scaling unit: 1 reserved: NOT SHOWN special string for scaling: NOT SHOWN reserved: NOT SHOW flag if calibration if valid: 1 current input values for "calib_value": 0 linear UNIT and used in the "poly_coeff": 1 ORDER of calibration POLYNOM: 1 valid calibration data pairs: 0 pixelpos. of calibration data: 0 0 0 0 0 0 0 0 0 0 calibration VALUE as above pos: 0 0 0 0 0 0 0 0 0 0 polynom COEFFICIENTS: 1 1 0 0 0 0 laser wavenumber for reative WN: 0 reserved: 0 If set to 200, valid label below: 0 Caliobration label (NULL term'd): NOT SHOWN Calibration Expansion area: NOT SHOWN ======================================================= Y Calibration data offset for absolute scaling: 0 factor for absolute scaling: 0 select scaling unit: 0 reserved: NOT SHOWN special string for scaling: NOT SHOWN reserved: NOT SHOW flag if calibration if valid: 0 current input values for "calib_value": 0 linear UNIT and used in the "poly_coeff": 0 ORDER of calibration POLYNOM: 0 valid calibration data pairs: 0 pixelpos. of calibration data: 0 0 0 0 0 0 0 0 0 0 calibration VALUE as above pos: 0 0 0 0 0 0 0 0 0 0 polynom COEFFICIENTS: 0 0 0 0 0 0 laser wavenumber for reative WN: 0 reserved: 0 If set to 200, valid label below: 0 Caliobration label (NULL term'd): NOT SHOWN Calibration Expansion area: NOT SHOWN End cal info======================================================= If set to 200, valid label below: 0 special intensity scaling string: NOT SHOWN Spare: NOT SHOWN spectrometer type: 0 (acton, spex, etc) spectrograph model: 0 (type dependent) pulser burst mode: 0 (on/off) pulser triggers per burst: 0 pulser burst period: 0 (usec) pulser bracket pulsing: 0 (on/off) pulser bracket pulsing type: 0 pulser fast exponential time constant: 0 (usec) pulser fast exponential amplitude constant: 0 (usec) pulser slow exponential time constant: 0 (usec) pulser slow exponential amplitude constant: 0 (usec) analog gain was used: 0 avalanche gain was used: 0 avalanche gain value: 0 Always the LAST value in the header: 21845 End HEADER======================================================= 1048576 Data values Read in as uint16 Data reshaped to 1024 by 1024 by 1 and converted to double Some Data ---------------------------------------------------------------- Row Column 1 101 201 301 401 501 601 701 801 901 1001 0001 395 596 595 592 589 600 595 602 597 601 594 0051 390 604 588 584 597 593 605 605 597 596 601 0101 389 602 587 593 594 600 601 597 590 601 601 0151 402 607 599 591 599 597 593 595 592 602 594 0201 399 606 594 592 585 601 593 616 595 602 606 0251 390 603 584 592 600 609 600 598 602 592 612 0301 401 603 594 592 596 606 601 603 616 600 602 0351 419 606 604 584 595 593 595 592 590 613 605 0401 396 599 592 598 588 599 602 602 596 601 611 0451 405 617 589 593 633 608 610 585 608 603 598 0501 403 609 592 600 601 601 632 628 603 607 618 0551 400 601 607 599 601 599 612 600 609 601 616 0601 399 606 601 588 592 601 596 602 616 595 614 0651 406 605 595 616 595 606 596 603 606 609 612 0701 408 608 600 583 590 607 604 610 609 616 615 0751 417 608 595 594 602 618 604 613 608 603 606 0801 403 607 589 594 605 607 593 600 606 614 602 0851 384 600 599 624 594 605 593 610 607 612 608 0901 415 605 598 599 603 612 625 605 630 615 609 0951 404 612 605 600 593 607 611 595 596 612 607 1001 410 614 594 604 599 607 594 606 621 609 611