alternative exposure, in sec: 0.1 Gain: 3 ADC rate: 6 date[DATEMAX]: 30Nov2009 Experiment Local Timing: 212814 (hhmmss or 0) Experiment UTC Timing: 212814 (hhmmss or 0) Shutter Control: 1 (Normal, Disabled Open, Disabled Close) experiment datatype: 3 (ushort) Number of Frames in File: 1 Number of Accumulations: 1 Experiment readout time: 9678.37 BackGround Applied: 0 (1 if background subraction done ) Auto Clean Active T/F: 0 flat Field Applied: 0 (1 if flat field was applied) Set to 1 if blemish removal applied: 0 Set to 1 if comsic raw removal applied: 0
Hardware Version: 0 Definition of OutPut BNC: 1 Amp Switching Mode: 0 Detector x dimension chip: 1024 timing mode: 1 alternative exposure, in sec: 0.1 Virtual Chip X dim: 0 Virtual Chip Y dim: 0 y dim of CCD or detector: 1024 date[DATEMAX]: 30Nov2009 Virtual Chip Flag On/Off: 0 Old numer of scans: -1 (should always be -1) Used with Asiny Mode: 0 Shutter Control: 1 (Normal, Disabled Open, Disabled Close) Absorb Live (On/Off): 0 Reference Strip or File: 0 Able to do Virtual Chip: 0 Threshold Min Live: 0 (On/Off) Threshold Minimun Value: 0 Threshold Max Live: 0 (On/Off) Threshold Maximum Value: 0 T/F Spectrograph Used: 0 Center Wavelength (nm): 0 T/F file is Glued: 0 Starting Wavelength (nm): 0 Ending Wavelength (nm): 0 Minimum Overlap (nm): 0 Final Resolution (nm): 0 Pulser Type: 0 (0 = None, PG200 = 1, PTG=2, DG535=3) T/F Custom Chip Used: 0 Pre Pixel in X direction: 0 Post Pixels in X direction: 8 Pre Pixel in Y direction: 24 Post Pixels in Y direction: 24 asynchron enable flag: 0 (0=off) experiment datatype: 3 (ushort) Repetitive/Sequential: 0 Num PTG On-Chip Accums: 0 Num Exp Repeats: 0 (Pulser SW Accum) Width Value for Rep. Pulse: 0 (usec) Delay? for Rep. Pulse: 0 (usec) Start Width for Seq. pulse: 0 (usec) End Width for Seq. pulse: 0 (usec) Start Delay for Seq. pulse: 0 (usec) End Delay for Seq. pulse: 0 (usec) Increments: 0 (1 = fixed, 2 = Exponential) PI-Max type controller flag: 0 PI-max mode: 0 PI-max gain: 0 BackGround Applied: 0 (1 if background subraction done ) T/F PI-max 2ns Board Used: 0 min # of strips per skips: 4 # of min-blocks before geo skps: 250 Spectro Mirror Location: 0 0 (0 = Not Present) Spectro Slit Location: 0 0 0 0 (0 = Not Present) T/F Custom Timing Used: 0 Experiment Local Timing: 212814 (hhmmss or 0) Experiment UTC Timing: 212814 (hhmmss or 0) User Units for Exposure: 3 ADC offset: 1878 ADC rate: 6 ADC type: 9 ADC resolution: 4 ADC bit adjust: 0 Gain: 3 File comments 1: File comments 2: File comments 3: File comments 4: File comments 5: geometric ops: 0 (rotate 0x01, reverse 0x02, flip 0x04) intensity display string: Pixel cleans: 1 number of skips per clean: 1024 Spectrograph Mirror Positions: 0 0 Spectrograph Slit Positions: 0 0 0 0 Auto Clean Active T/F: 0 UseContCleanActive T/F: 0 Absorb Strip Number: 0 Spectrograph Slit Pos. Units: 0 Spectrograph Grating Grooves: 0 # of source comp. diodes: 0 y dimension of raw data: 1024 0 = scrambled, 1 = unscramble: 1 T/F Continuous Cleans Timing Option: 0 T/F External Trigger Timing Option: 0 Number of scans (Early WinX): -1 Number of Accumulations: 1 Experiment readout time: 9678.37 T/F Triggered Timing Option: 0 Spare 2: Version of SW creating this file: 2.5.25 Mar2009 Type: 22 (This type does not exist) flat Field Applied: 0 (1 if flat field was applied) Spare_3: Kinetics Trigger Mode: 1 Data Label: Intensity Spare_4: Name of Pulser File: (with Pulse Widths/Delays (for Z-Slice)) Name of Absorbtance File: (if FIle Mode) Number of time experiment repeated: 0 Number of time experiment accumulated: 0 Set to 1 if this file contains YT data: 0 Vert Clock Speed in micro_sec: 0 Set to 1 if accum done by Hardware: 0 Set to 1 if store sync used: 1 Set to 1 if blemish removal applied: 0 Set to 1 if comsic raw removal applied: 0 if cosmic ray applied, this is type: 0 Threshold of cosmiv ray removal: 50 Number of Frames in File: 1 max intensity data (future): 0 min intensity data (future): 0 y axis label: Strip shutter type: 6 shutter compensation time: 0 readout mode: 1 (full, kinetic, etc) window size for knietics only: 0 clock speed for kinetics and frame transfer: 0 computer interface : 22 (isa-taxi,pci, eisa, etc.) Num of ROI: May be more than the 10 allowed in this header (if 0 assume 1) Num ROIs In Experiment: 1 (May be more than the 10 allowed in this header (if 0 assume 1)) Spare_5: Controller Num: 1 (if multiple controllers system will have controller number data came from. This is a future item) Which software package created this file: 1 number of ROIs used: 1 (if 0, assume 1) left x start value: 1 0 0 0 0 0 0 0 0 0 right x start value: 1024 0 0 0 0 0 0 0 0 0 amount x is binned in hw: 1 0 0 0 0 0 0 0 0 0 top y start value: 1 0 0 0 0 0 0 0 0 0 bottom y start value: 1024 0 0 0 0 0 0 0 0 0 amount y is binned/grouped in hw: 1 0 0 0 0 0 0 0 0 0 Flat field file name: background sub. file name: blemish file name: version of this file header: 2.2 Reserved for YT information: 0x01234567L if file created by WinX: 1.90887e+007 ======================================================= X Calibration data offset for absolute scaling: 0 factor for absolute scaling: 0 select scaling unit: 1 reserved: NOT SHOWN special string for scaling: NOT SHOWN reserved: NOT SHOW flag if calibration if valid: 1 current input values for "calib_value": 0 linear UNIT and used in the "poly_coeff": 1 ORDER of calibration POLYNOM: 1 valid calibration data pairs: 0 pixelpos. of calibration data: 0 0 0 0 0 0 0 0 0 0 calibration VALUE as above pos: 0 0 0 0 0 0 0 0 0 0 polynom COEFFICIENTS: 1 1 0 0 0 0 laser wavenumber for reative WN: 0 reserved: 0 If set to 200, valid label below: 0 Caliobration label (NULL term'd): NOT SHOWN Calibration Expansion area: NOT SHOWN ======================================================= Y Calibration data offset for absolute scaling: 0 factor for absolute scaling: 0 select scaling unit: 0 reserved: NOT SHOWN special string for scaling: NOT SHOWN reserved: NOT SHOW flag if calibration if valid: 0 current input values for "calib_value": 0 linear UNIT and used in the "poly_coeff": 0 ORDER of calibration POLYNOM: 0 valid calibration data pairs: 0 pixelpos. of calibration data: 0 0 0 0 0 0 0 0 0 0 calibration VALUE as above pos: 0 0 0 0 0 0 0 0 0 0 polynom COEFFICIENTS: 0 0 0 0 0 0 laser wavenumber for reative WN: 0 reserved: 0 If set to 200, valid label below: 0 Caliobration label (NULL term'd): NOT SHOWN Calibration Expansion area: NOT SHOWN End cal info======================================================= If set to 200, valid label below: 0 special intensity scaling string: NOT SHOWN Spare: NOT SHOWN spectrometer type: 0 (acton, spex, etc) spectrograph model: 0 (type dependent) pulser burst mode: 0 (on/off) pulser triggers per burst: 0 pulser burst period: 0 (usec) pulser bracket pulsing: 0 (on/off) pulser bracket pulsing type: 0 pulser fast exponential time constant: 0 (usec) pulser fast exponential amplitude constant: 0 (usec) pulser slow exponential time constant: 0 (usec) pulser slow exponential amplitude constant: 0 (usec) analog gain was used: 0 avalanche gain was used: 0 avalanche gain value: 0 Always the LAST value in the header: 21845 End HEADER======================================================= 1048576 Data values Read in as uint16 Data reshaped to 1024 by 1024 by 1 and converted to double Some Data ---------------------------------------------------------------- Row Column 1 101 201 301 401 501 601 701 801 901 1001 0001 395 600 594 594 604 604 601 596 599 603 597 0051 405 596 594 587 592 615 586 589 608 596 604 0101 399 603 582 598 601 597 592 604 609 602 605 0151 403 605 579 585 594 608 622 598 607 619 598 0201 395 598 599 585 613 598 589 596 597 593 627 0251 400 612 614 613 591 622 605 598 604 600 627 0301 403 591 596 586 614 589 600 607 600 611 623 0351 405 611 590 582 600 606 602 584 612 601 606 0401 396 605 592 588 600 598 596 605 617 599 615 0451 386 601 598 607 599 616 604 619 624 604 608 0501 403 605 603 590 603 599 599 614 616 604 606 0551 411 621 595 604 605 617 605 611 616 620 602 0601 416 602 594 597 599 603 608 603 615 609 610 0651 399 602 591 597 608 611 611 609 612 614 603 0701 409 607 605 596 597 615 602 598 612 610 612 0751 409 600 591 596 586 600 596 625 610 600 623 0801 399 596 600 599 610 588 593 621 598 613 605 0851 413 602 602 594 593 611 599 612 616 615 608 0901 409 606 608 584 612 606 601 596 618 619 602 0951 403 604 599 592 599 608 605 617 595 622 614 1001 409 610 594 599 602 621 592 603 619 607 597