alternative exposure, in sec: 0.1 Gain: 3 ADC rate: 6 date[DATEMAX]: 04Dec2009 Experiment Local Timing: 205526 (hhmmss or 0) Experiment UTC Timing: 205526 (hhmmss or 0) Shutter Control: 2 (Normal, Disabled Open, Disabled Close) experiment datatype: 3 (ushort) Number of Frames in File: 1 Number of Accumulations: 1 Experiment readout time: 9678.37 BackGround Applied: 0 (1 if background subraction done ) Auto Clean Active T/F: 0 flat Field Applied: 0 (1 if flat field was applied) Set to 1 if blemish removal applied: 0 Set to 1 if comsic raw removal applied: 0
Hardware Version: 0 Definition of OutPut BNC: 1 Amp Switching Mode: 0 Detector x dimension chip: 1024 timing mode: 1 alternative exposure, in sec: 0.1 Virtual Chip X dim: 0 Virtual Chip Y dim: 0 y dim of CCD or detector: 1024 date[DATEMAX]: 04Dec2009 Virtual Chip Flag On/Off: 0 Old numer of scans: -1 (should always be -1) Used with Asiny Mode: 0 Shutter Control: 2 (Normal, Disabled Open, Disabled Close) Absorb Live (On/Off): 0 Reference Strip or File: 0 Able to do Virtual Chip: 0 Threshold Min Live: 0 (On/Off) Threshold Minimun Value: 0 Threshold Max Live: 0 (On/Off) Threshold Maximum Value: 0 T/F Spectrograph Used: 0 Center Wavelength (nm): 0 T/F file is Glued: 0 Starting Wavelength (nm): 0 Ending Wavelength (nm): 0 Minimum Overlap (nm): 0 Final Resolution (nm): 0 Pulser Type: 0 (0 = None, PG200 = 1, PTG=2, DG535=3) T/F Custom Chip Used: 0 Pre Pixel in X direction: 0 Post Pixels in X direction: 8 Pre Pixel in Y direction: 24 Post Pixels in Y direction: 24 asynchron enable flag: 0 (0=off) experiment datatype: 3 (ushort) Repetitive/Sequential: 0 Num PTG On-Chip Accums: 0 Num Exp Repeats: 0 (Pulser SW Accum) Width Value for Rep. Pulse: 0 (usec) Delay? for Rep. Pulse: 0 (usec) Start Width for Seq. pulse: 0 (usec) End Width for Seq. pulse: 0 (usec) Start Delay for Seq. pulse: 0 (usec) End Delay for Seq. pulse: 0 (usec) Increments: 0 (1 = fixed, 2 = Exponential) PI-Max type controller flag: 0 PI-max mode: 0 PI-max gain: 0 BackGround Applied: 0 (1 if background subraction done ) T/F PI-max 2ns Board Used: 0 min # of strips per skips: 4 # of min-blocks before geo skps: 250 Spectro Mirror Location: 0 0 (0 = Not Present) Spectro Slit Location: 0 0 0 0 (0 = Not Present) T/F Custom Timing Used: 0 Experiment Local Timing: 205526 (hhmmss or 0) Experiment UTC Timing: 205526 (hhmmss or 0) User Units for Exposure: 3 ADC offset: 1878 ADC rate: 6 ADC type: 9 ADC resolution: 4 ADC bit adjust: 0 Gain: 3 File comments 1: File comments 2: File comments 3: File comments 4: File comments 5: geometric ops: 0 (rotate 0x01, reverse 0x02, flip 0x04) intensity display string: Pixel cleans: 1 number of skips per clean: 1024 Spectrograph Mirror Positions: 0 0 Spectrograph Slit Positions: 0 0 0 0 Auto Clean Active T/F: 0 UseContCleanActive T/F: 0 Absorb Strip Number: 0 Spectrograph Slit Pos. Units: 0 Spectrograph Grating Grooves: 0 # of source comp. diodes: 0 y dimension of raw data: 1024 0 = scrambled, 1 = unscramble: 1 T/F Continuous Cleans Timing Option: 0 T/F External Trigger Timing Option: 0 Number of scans (Early WinX): -1 Number of Accumulations: 1 Experiment readout time: 9678.37 T/F Triggered Timing Option: 0 Spare 2: Version of SW creating this file: 2.5.25 Mar2009 Type: 22 (This type does not exist) flat Field Applied: 0 (1 if flat field was applied) Spare_3: Kinetics Trigger Mode: 1 Data Label: Intensity Spare_4: Name of Pulser File: (with Pulse Widths/Delays (for Z-Slice)) Name of Absorbtance File: (if FIle Mode) Number of time experiment repeated: 0 Number of time experiment accumulated: 0 Set to 1 if this file contains YT data: 0 Vert Clock Speed in micro_sec: 0 Set to 1 if accum done by Hardware: 0 Set to 1 if store sync used: 1 Set to 1 if blemish removal applied: 0 Set to 1 if comsic raw removal applied: 0 if cosmic ray applied, this is type: 0 Threshold of cosmiv ray removal: 50 Number of Frames in File: 1 max intensity data (future): 0 min intensity data (future): 0 y axis label: Strip shutter type: 6 shutter compensation time: 0 readout mode: 1 (full, kinetic, etc) window size for knietics only: 0 clock speed for kinetics and frame transfer: 0 computer interface : 22 (isa-taxi,pci, eisa, etc.) Num of ROI: May be more than the 10 allowed in this header (if 0 assume 1) Num ROIs In Experiment: 1 (May be more than the 10 allowed in this header (if 0 assume 1)) Spare_5: Controller Num: 1 (if multiple controllers system will have controller number data came from. This is a future item) Which software package created this file: 1 number of ROIs used: 1 (if 0, assume 1) left x start value: 1 0 0 0 0 0 0 0 0 0 right x start value: 1024 0 0 0 0 0 0 0 0 0 amount x is binned in hw: 1 0 0 0 0 0 0 0 0 0 top y start value: 1 0 0 0 0 0 0 0 0 0 bottom y start value: 1024 0 0 0 0 0 0 0 0 0 amount y is binned/grouped in hw: 1 0 0 0 0 0 0 0 0 0 Flat field file name: background sub. file name: blemish file name: version of this file header: 2.2 Reserved for YT information: 0x01234567L if file created by WinX: 1.90887e+007 ======================================================= X Calibration data offset for absolute scaling: 0 factor for absolute scaling: 0 select scaling unit: 1 reserved: NOT SHOWN special string for scaling: NOT SHOWN reserved: NOT SHOW flag if calibration if valid: 1 current input values for "calib_value": 0 linear UNIT and used in the "poly_coeff": 1 ORDER of calibration POLYNOM: 1 valid calibration data pairs: 0 pixelpos. of calibration data: 0 0 0 0 0 0 0 0 0 0 calibration VALUE as above pos: 0 0 0 0 0 0 0 0 0 0 polynom COEFFICIENTS: 1 1 0 0 0 0 laser wavenumber for reative WN: 0 reserved: 0 If set to 200, valid label below: 0 Caliobration label (NULL term'd): NOT SHOWN Calibration Expansion area: NOT SHOWN ======================================================= Y Calibration data offset for absolute scaling: 0 factor for absolute scaling: 0 select scaling unit: 0 reserved: NOT SHOWN special string for scaling: NOT SHOWN reserved: NOT SHOW flag if calibration if valid: 0 current input values for "calib_value": 0 linear UNIT and used in the "poly_coeff": 0 ORDER of calibration POLYNOM: 0 valid calibration data pairs: 0 pixelpos. of calibration data: 0 0 0 0 0 0 0 0 0 0 calibration VALUE as above pos: 0 0 0 0 0 0 0 0 0 0 polynom COEFFICIENTS: 0 0 0 0 0 0 laser wavenumber for reative WN: 0 reserved: 0 If set to 200, valid label below: 0 Caliobration label (NULL term'd): NOT SHOWN Calibration Expansion area: NOT SHOWN End cal info======================================================= If set to 200, valid label below: 0 special intensity scaling string: NOT SHOWN Spare: NOT SHOWN spectrometer type: 0 (acton, spex, etc) spectrograph model: 0 (type dependent) pulser burst mode: 0 (on/off) pulser triggers per burst: 0 pulser burst period: 0 (usec) pulser bracket pulsing: 0 (on/off) pulser bracket pulsing type: 0 pulser fast exponential time constant: 0 (usec) pulser fast exponential amplitude constant: 0 (usec) pulser slow exponential time constant: 0 (usec) pulser slow exponential amplitude constant: 0 (usec) analog gain was used: 0 avalanche gain was used: 0 avalanche gain value: 0 Always the LAST value in the header: 21845 End HEADER======================================================= 1048576 Data values Read in as uint16 Data reshaped to 1024 by 1024 by 1 and converted to double Some Data ---------------------------------------------------------------- Row Column 1 101 201 301 401 501 601 701 801 901 1001 0001 397 586 599 586 600 596 602 605 597 593 599 0051 395 606 590 594 596 598 598 601 603 602 613 0101 398 601 602 594 589 601 610 590 619 604 622 0151 403 594 589 593 615 604 609 594 602 597 601 0201 404 600 593 592 597 606 612 594 596 601 591 0251 407 611 596 593 601 603 601 597 608 601 603 0301 397 610 591 601 604 603 606 602 609 600 609 0351 409 606 588 587 601 603 604 600 605 622 602 0401 405 597 587 597 599 595 607 601 603 598 595 0451 414 615 598 597 600 615 586 608 609 597 610 0501 411 603 592 589 598 614 601 604 608 605 609 0551 401 594 593 587 600 607 608 597 603 598 612 0601 402 606 601 593 604 613 598 601 597 599 609 0651 412 607 583 592 622 620 598 604 612 597 596 0701 406 628 600 590 596 617 594 600 606 609 607 0751 404 602 602 600 593 603 606 598 608 610 609 0801 430 604 593 620 601 611 620 601 602 608 610 0851 409 583 594 608 606 614 604 602 602 623 609 0901 414 597 607 587 604 607 623 606 624 620 610 0951 412 607 602 611 611 606 608 599 611 606 620 1001 413 622 605 607 597 603 600 596 612 604 608