alternative exposure, in sec: 0.1 Gain: 3 ADC rate: 6 date[DATEMAX]: 04Dec2009 Experiment Local Timing: 233244 (hhmmss or 0) Experiment UTC Timing: 233244 (hhmmss or 0) Shutter Control: 2 (Normal, Disabled Open, Disabled Close) experiment datatype: 3 (ushort) Number of Frames in File: 1 Number of Accumulations: 1 Experiment readout time: 9678.37 BackGround Applied: 0 (1 if background subraction done ) Auto Clean Active T/F: 0 flat Field Applied: 0 (1 if flat field was applied) Set to 1 if blemish removal applied: 0 Set to 1 if comsic raw removal applied: 0
Hardware Version: 0 Definition of OutPut BNC: 1 Amp Switching Mode: 0 Detector x dimension chip: 1024 timing mode: 1 alternative exposure, in sec: 0.1 Virtual Chip X dim: 0 Virtual Chip Y dim: 0 y dim of CCD or detector: 1024 date[DATEMAX]: 04Dec2009 Virtual Chip Flag On/Off: 0 Old numer of scans: -1 (should always be -1) Used with Asiny Mode: 0 Shutter Control: 2 (Normal, Disabled Open, Disabled Close) Absorb Live (On/Off): 0 Reference Strip or File: 0 Able to do Virtual Chip: 0 Threshold Min Live: 0 (On/Off) Threshold Minimun Value: 0 Threshold Max Live: 0 (On/Off) Threshold Maximum Value: 0 T/F Spectrograph Used: 0 Center Wavelength (nm): 0 T/F file is Glued: 0 Starting Wavelength (nm): 0 Ending Wavelength (nm): 0 Minimum Overlap (nm): 0 Final Resolution (nm): 0 Pulser Type: 0 (0 = None, PG200 = 1, PTG=2, DG535=3) T/F Custom Chip Used: 0 Pre Pixel in X direction: 0 Post Pixels in X direction: 8 Pre Pixel in Y direction: 24 Post Pixels in Y direction: 24 asynchron enable flag: 0 (0=off) experiment datatype: 3 (ushort) Repetitive/Sequential: 0 Num PTG On-Chip Accums: 0 Num Exp Repeats: 0 (Pulser SW Accum) Width Value for Rep. Pulse: 0 (usec) Delay? for Rep. Pulse: 0 (usec) Start Width for Seq. pulse: 0 (usec) End Width for Seq. pulse: 0 (usec) Start Delay for Seq. pulse: 0 (usec) End Delay for Seq. pulse: 0 (usec) Increments: 0 (1 = fixed, 2 = Exponential) PI-Max type controller flag: 0 PI-max mode: 0 PI-max gain: 0 BackGround Applied: 0 (1 if background subraction done ) T/F PI-max 2ns Board Used: 0 min # of strips per skips: 4 # of min-blocks before geo skps: 250 Spectro Mirror Location: 0 0 (0 = Not Present) Spectro Slit Location: 0 0 0 0 (0 = Not Present) T/F Custom Timing Used: 0 Experiment Local Timing: 233244 (hhmmss or 0) Experiment UTC Timing: 233244 (hhmmss or 0) User Units for Exposure: 3 ADC offset: 1878 ADC rate: 6 ADC type: 9 ADC resolution: 4 ADC bit adjust: 0 Gain: 3 File comments 1: File comments 2: File comments 3: File comments 4: File comments 5: geometric ops: 0 (rotate 0x01, reverse 0x02, flip 0x04) intensity display string: Pixel cleans: 1 number of skips per clean: 1024 Spectrograph Mirror Positions: 0 0 Spectrograph Slit Positions: 0 0 0 0 Auto Clean Active T/F: 0 UseContCleanActive T/F: 0 Absorb Strip Number: 0 Spectrograph Slit Pos. Units: 0 Spectrograph Grating Grooves: 0 # of source comp. diodes: 0 y dimension of raw data: 1024 0 = scrambled, 1 = unscramble: 1 T/F Continuous Cleans Timing Option: 0 T/F External Trigger Timing Option: 0 Number of scans (Early WinX): -1 Number of Accumulations: 1 Experiment readout time: 9678.37 T/F Triggered Timing Option: 0 Spare 2: Version of SW creating this file: 2.5.25 Mar2009 Type: 22 (This type does not exist) flat Field Applied: 0 (1 if flat field was applied) Spare_3: Kinetics Trigger Mode: 1 Data Label: Intensity Spare_4: Name of Pulser File: (with Pulse Widths/Delays (for Z-Slice)) Name of Absorbtance File: (if FIle Mode) Number of time experiment repeated: 0 Number of time experiment accumulated: 0 Set to 1 if this file contains YT data: 0 Vert Clock Speed in micro_sec: 0 Set to 1 if accum done by Hardware: 0 Set to 1 if store sync used: 1 Set to 1 if blemish removal applied: 0 Set to 1 if comsic raw removal applied: 0 if cosmic ray applied, this is type: 0 Threshold of cosmiv ray removal: 50 Number of Frames in File: 1 max intensity data (future): 0 min intensity data (future): 0 y axis label: Strip shutter type: 6 shutter compensation time: 0 readout mode: 1 (full, kinetic, etc) window size for knietics only: 0 clock speed for kinetics and frame transfer: 0 computer interface : 22 (isa-taxi,pci, eisa, etc.) Num of ROI: May be more than the 10 allowed in this header (if 0 assume 1) Num ROIs In Experiment: 1 (May be more than the 10 allowed in this header (if 0 assume 1)) Spare_5: Controller Num: 1 (if multiple controllers system will have controller number data came from. This is a future item) Which software package created this file: 1 number of ROIs used: 1 (if 0, assume 1) left x start value: 1 0 0 0 0 0 0 0 0 0 right x start value: 1024 0 0 0 0 0 0 0 0 0 amount x is binned in hw: 1 0 0 0 0 0 0 0 0 0 top y start value: 1 0 0 0 0 0 0 0 0 0 bottom y start value: 1024 0 0 0 0 0 0 0 0 0 amount y is binned/grouped in hw: 1 0 0 0 0 0 0 0 0 0 Flat field file name: background sub. file name: blemish file name: version of this file header: 2.2 Reserved for YT information: 0x01234567L if file created by WinX: 1.90887e+007 ======================================================= X Calibration data offset for absolute scaling: 0 factor for absolute scaling: 0 select scaling unit: 1 reserved: NOT SHOWN special string for scaling: NOT SHOWN reserved: NOT SHOW flag if calibration if valid: 1 current input values for "calib_value": 0 linear UNIT and used in the "poly_coeff": 1 ORDER of calibration POLYNOM: 1 valid calibration data pairs: 0 pixelpos. of calibration data: 0 0 0 0 0 0 0 0 0 0 calibration VALUE as above pos: 0 0 0 0 0 0 0 0 0 0 polynom COEFFICIENTS: 1 1 0 0 0 0 laser wavenumber for reative WN: 0 reserved: 0 If set to 200, valid label below: 0 Caliobration label (NULL term'd): NOT SHOWN Calibration Expansion area: NOT SHOWN ======================================================= Y Calibration data offset for absolute scaling: 0 factor for absolute scaling: 0 select scaling unit: 0 reserved: NOT SHOWN special string for scaling: NOT SHOWN reserved: NOT SHOW flag if calibration if valid: 0 current input values for "calib_value": 0 linear UNIT and used in the "poly_coeff": 0 ORDER of calibration POLYNOM: 0 valid calibration data pairs: 0 pixelpos. of calibration data: 0 0 0 0 0 0 0 0 0 0 calibration VALUE as above pos: 0 0 0 0 0 0 0 0 0 0 polynom COEFFICIENTS: 0 0 0 0 0 0 laser wavenumber for reative WN: 0 reserved: 0 If set to 200, valid label below: 0 Caliobration label (NULL term'd): NOT SHOWN Calibration Expansion area: NOT SHOWN End cal info======================================================= If set to 200, valid label below: 0 special intensity scaling string: NOT SHOWN Spare: NOT SHOWN spectrometer type: 0 (acton, spex, etc) spectrograph model: 0 (type dependent) pulser burst mode: 0 (on/off) pulser triggers per burst: 0 pulser burst period: 0 (usec) pulser bracket pulsing: 0 (on/off) pulser bracket pulsing type: 0 pulser fast exponential time constant: 0 (usec) pulser fast exponential amplitude constant: 0 (usec) pulser slow exponential time constant: 0 (usec) pulser slow exponential amplitude constant: 0 (usec) analog gain was used: 0 avalanche gain was used: 0 avalanche gain value: 0 Always the LAST value in the header: 21845 End HEADER======================================================= 1048576 Data values Read in as uint16 Data reshaped to 1024 by 1024 by 1 and converted to double Some Data ---------------------------------------------------------------- Row Column 1 101 201 301 401 501 601 701 801 901 1001 0001 393 588 591 591 593 587 619 604 603 597 595 0051 403 598 594 582 598 608 615 592 595 598 602 0101 394 606 594 605 592 598 594 597 591 607 604 0151 400 590 593 589 596 598 589 594 610 591 602 0201 411 600 594 586 590 607 595 599 616 610 605 0251 404 616 596 590 613 601 593 602 594 608 595 0301 404 604 585 591 596 612 592 600 597 612 592 0351 400 606 603 594 591 596 593 605 607 600 613 0401 400 609 592 597 595 591 601 605 602 605 592 0451 406 601 590 598 598 619 598 609 604 601 595 0501 403 599 596 599 601 582 606 601 618 606 607 0551 417 597 592 589 592 602 610 607 595 604 616 0601 414 609 604 592 602 606 603 598 600 597 601 0651 408 621 593 598 609 611 618 614 615 620 611 0701 399 610 596 599 621 608 605 596 603 619 600 0751 408 606 597 599 590 601 609 598 617 604 609 0801 400 611 600 602 606 613 595 598 613 606 610 0851 401 617 594 590 597 604 612 614 610 599 608 0901 418 619 594 605 596 609 596 607 601 617 607 0951 400 600 596 632 604 601 608 600 600 606 600 1001 400 610 597 598 600 605 598 605 603 594 620